Click for larger | Named after a good friend who came up with the idea. Shown here in use on a twin mattress (and they left me there for 3 hours after the shot!), the sketches show how these nylon webbing bonds are designed. The sketch on the left is the basic, the right is the deluxe. The box you see in the sketch is to show where the mattress would lay, holding the bonds in place, which allows you to hold the person you want firmly in position. These units are portable, but no where near as much so as our three piece bed bonds. Ideally, they will convert a bed permanently to a bondage device, and the rings can be tucked away, sight unseen, until needed again. Made of 1 1/2" nylon webbing, with large "D" rings, they have a break strength of 710 pounds, so I doubt that you know anyone who will be ripping these apart. These are the same bed bonds that were featured in Bound and Gagged and KW Enterprises. Designed to fit specific size mattresses, please select from the chart below. Our original design was not made to fit high-rise mattresses (also called pillow-top). While they could work, the "D" rings were a little hard to get to. We now make them specifically for people with the high rise mattresses. Standard mattresses normally are about 8" high, while the high rise ones are more like 15". If your mattress is between 8" and 15" then you will have to pick between the two. If you pick the high rise, the D rings will lay on the mattress a little. If you pick the standard, they will miss the top of the mattress a little. Both will work fine, but if you want all of the area available for a really good stretch, I suggest the standard. |